Product discontinued. Successor model: NF-S12B ULN

Sound-optimised blade geometry and profile: The NF-S12 is the first fan employing a novel rotor which was developed by the Austrian Institute for Heat-Transmission and Fan Technology (Österreichisches Institut für Wärmeübertragung und Ventilatorentechnik, ÖIWV). Thanks to the special optimisation of the blade geometry towards ultra low noise application, the NF-S12 is up to 10% more quiet than current high-end fans at the same flow rate.

Self-stabilising oil-pressure bearing (SSO bearing): The NF-S12 series are equipped with a magnetically centred, self lubricating oil-pressure bearing that provides a new level of quietness and long-term stability.
FAN Specification
120x120x25 mm
Blade Geometry
Rotational Speed (+/- 10%)
800 RPM
Rotational Speed with U.L.N.A. (+/- 10%)
500 RPM
59 m³/h
Airflow with U.L.N.A.
34 m³/h
Acoustical Noise
8 dB(A)
Acoustical Noise with U.L.N.A.
< 5* dB(A)
> 150.000 h
Scope of Delivery
  • Ultra-Low-Noise Adaptor (U.L.N.A.)
  • 4 Vibration Compensators
  • 3:4-Pin Adaptor
  • 4 Fan Screws
6 years

Information Sheet (PDF)

Can I use Noctua fans on my fan controller?

Our fans are compatible with the vast majority of fan controllers on the market. However, there is a compatibility issue with a few models such as the Zalman ZM-MFC2 and Bitfenix Recon, which apply Pulse Width Modulation (PWM) on the 12V line and use an unfavourable PWM carrier frequency. This can create an oscillation when used with certain fans, which will result in the fan speeding up and down. We therefore recommend not using the Zalman ZM-MFC2 or Bitfenix Recon with our fans.

My fan doesn’t spin when I start up the PC - is it faulty?

If you've connected the fan directly (or using the supplied Low-Noise or Ultra-Low-Noise-Adaptors) to your mainboard, it's possible that the mainboard's automatic fan controller doesn't provide the required starting voltage due to the low CPU temperature. Please verify whether the fan starts spinning at higher CPU temperatures, remove any Low-Noise or Ultra-Low-Noise Adaptors, deactivate your mainboard's automatic fan controller in the BIOS or connect the fan directly to the power supply using the supplied 3:4-pin adaptor.

Can I run Noctua 3-pin fans on 4-pin PWM connectors and use my mainboard’s automatic fan controller?

You can simply connect our fan's 3-pin connector to the 4-pin PWM sockets of today's mainboards so that the fourth pin that transmits the PWM signal is left blank (due to the shape of the connector, there's no danger of reversing polarity). Some mainboards (e.g. current Gigabyte models) are capable of controlling fans not only via PWM, but also by adjusting the supplied voltage. In some cases, this may require you to change BIOS options like "Fan Control Mode" from "PWM" to "Voltage" or "Analog". Please consult your mainboard's manual in this regard. However, some mainboards use an "auto" setting by default that automatically chooses PWM or voltage based regulation according to the connected fan. Automatically controlling the fan speed may not possible on mainboards that pulse the power rather than lowering the fan voltage.


Do you have a question concerning one of our products? Please use this form to pose a question!