NM-DD1 Order Form

Thank you very much for your interest in our NM-DD1 direct die mounting kit. Please take note of the following points before submitting your request:

The NM-DD1 can be ordered exclusively via this form for a service charge of EUR 4.90.

Alternatively, customers can 3D-print the spacers contained in the NM-DD1 kit at home using the STL files shared at Printables.com (NM-DDS1 spacers for coolers with two-piece fastening brackets and 83mm mounting-pitch, NM-DDS2 spacers for coolers with a single-piece fastening bracket and 78mm mounting pitch). Installing the fastening bracket(s) with the printed spacers will require four M3x12 screws (for NM-DDS1) or a single M4x10 screw (for NM-DDS2).

Caution: Direct die cooling is done at your own risk! While high-quality delidding tools and direct die frames like those from der8auer have been thoughtfully engineered to minimise the risk of damaging the CPU or other hardware components, direct die cooling will always bear a certain risk of damaging components e.g. due to cracked edges on the bare CPU dies or short circuits from liquid metal compound. Delidding will also void the processors’ warranty. Therefore, using the NM-DD1 is strictly at the customer’s own risk and Noctua cannot be held responsible for any damage that may occur to CPUs or other hardware components when removing the heat spreader and using direct die cooling.

Delivery may take up to 2 weeks depending on your destination. Depending on the country, express shipping options may be available but are subject to extra charges.

The data submitted via the form below is used as shipping address. Please therefore make sure to provide your complete delivery address (including house number and, if applicable, door/flat/apartment number, etc.).

Customs duties may apply when ordering through this form.